Page 139 - Window and Door Hardware Catalog

SaSh Support SyStemS

SASH PREPARATION AND INSTRUCTIONS FOR HEAVY DUTY MAGNUM
Sash Preparation for Single Double Hung Frame Applications Single Hung Frame Applications
and Double Hung and Sash Pre-fit and Sash Pre-fit

Bracket Flange

Frame Jamb Preparation for
Bracket Application

HOW TO INSTALL TILT JAMBLINERS
1. If you are converting a window from a Non-Tilt to a Tilt 3. Apply jambliners to jambs, with 4. Install sash brackets in upper and 5. Insert upper sash into opening in full
window or if you are retrofitting a window that previously bottom touching the sill and flange lower sash as shown below. tilt position. Align pivot pins in the proper
used pulleys or other balances -you must cut back the side touching the blind stop. channel above carriers. Allow pins to
sash by 11/16" on each side, reducing the overall sash Press jambliner and drive screws until UPPER drop into carriers. Pivot sash into place.
width by 1-3/8". (See Figure 1.) head is flush with liner. Readjustment SASH Repeat for lower sash. Then reinstall the
of screws may be necessary during inside trim stops and head parting stop.
STEP 5.
Figure 1
LOWER
SASH

2. Make a 5/8" square x 3/16" deep plough on both
sides of sash. (See Figure 1.)
139
© 2023 PGI.